Initially, it is necessary to disconnect the minus terminal from the battery; Insert the key into the ignition lock, this corresponds to the position «0»; Open the plastic casing in which the steering mechanism is located, unscrew the screws, open the elements of the case and remove them; To unscrew the screws holding the ignition […]

Procedure for the work: carrying out work on the replacement of electrical equipment by car must be performed in compliance with safety precautions, disconnecting the voltage of the on -board network.

You can replace the ignition lock on your own.

The motorist inserts the key into the ignition lock, but the starter does not work, does not twist.

Over time, either the key may break or the ignition lock.

There are two cases of replacing the ignition lock.

If necessary, you can change the on -board computer settings at any time.

After its implementation, you will have to install fuel consumption modes, oil pressure, as well as the desired temperature in the cabin.

Find the gray wire under it and connect the green wire to it.

To connect the fuel sensor will have to spend time disassembling the door.