We note that during this year, the Volzhsky Automobile Plant plans to launch the production of two new models on the basis of B0, but on their own capacities.

It is also known that this metal is needed for models planned to be developed jointly with Renault-Nissan.

Nowhere is it mentioned about the volume of procurement.

For the first time over the past 20 years, the largest Russian car manufacturer decides to switch to steel supply of imported production.

Having carried out the above actions, you can change the car, turn off the strobe and be sure to tighten the fastener bolt on the trambler.

To set the ignition, it is necessary: ​​to drown out the motor and, observing the polarity, connect the device to the battery; Fix the signal cable on the wire, which is connected to the candle of the 1st cylinder; On the body of the power unit and the flywheel of the crankshaft, you need to […]

How to set the ignition using a strobe scrap?

Next, phased actions go: from the 4th cylinder, unscrew the candle, the formed hole can be plugged with a pink of paper; Scroll through the crankshaft behind the chipper nut; If the paper plug flew out, then the piston approached the VMT, and the valves are closed; Look for a pulley mark, and then drive […]

This is quite simple: when the valve cover is removed, the 7th and 8th valves are pressed (during the compression cycle, as well as when serving a spark).

In this way, you can pull a mechanical tensioner (pilot).